Going WC again. On the right track?

[EnJoY]

Needs more pump.

Why isn't your reservoir cap fully screwed down?

[wez]

Needs more pump.

Why isn't your reservoir cap fully screwed down?

More pumping power is on its way
Res cap was loose cus I used it to fill the loop, and forgot to screw it back on when done :P

[The Duke]

looking good so far

how is the spacing inside there? easy to work with and all that?

[wez]

looking good so far

how is the spacing inside there? easy to work with and all that?

Well, as its open on all sides its pretty easy to reach stuff if you can move it around. But it weights a ton atm, and when mainly made of plexi its pretty "hard" to move around.. But over all its a great table, good combo of looks and function imo Long mobo stand offs, so good room for insulation/backplates/mods/cables or whatever you'd want to tuck in there Also large precut opening behind the CPU area is nice. However, square pillars instead of round would have been sweet. Would have been great to mount stuff on

Found this btw http://www1.acryan.com/_constructx/acr-cx31069.shtml
Think I'll grab one of those to replace the original hdd stand. And got an idea about turning one into a pump stand as well

[The Duke]

trying to figure your loop out with your 30ft of tubing
is it pump > rad > res > CPU ?

[wez]

trying to figure your loop out with your 30ft of tubing
is it pump > rad > res > CPU ?

Yea i like tubing
pump -> rad -> rad -> cpu -> res

[wez]

Converted the 5.25" holder into a new hdd cage today. Tight fit, but got all drives in it

[The Duke]

very nice looking HD tray

[EnJoY]

Nice stuff wez!

Will we see a blog of the finished product?

[wez]

Nice stuff wez!

Will we see a blog of the finished product?

Aye, will get a post up

[wez]

Haven't done anything on this for a while now. But slowly getting the last parts needed to get started again Quite a few changes also, both for cooling and looks

Rig have been running great, so nothing to complain about on that front at least Other than being a bit concerned about the stress to the plexi, due to high weight load in some areas...

A more interesting update will come later this week hopefully

[The Duke]

very cool!
can't wait for the updated pics.

Have you thought about maybe building a little plexi glass support for the high weight areas? Is there not enough room for that?

[wez]

very cool!
can't wait for the updated pics.

Have you thought about maybe building a little plexi glass support for the high weight areas? Is there not enough room for that?

Hmm, not a lot of room as it looks right now.
But going thru some stuff at home I found some small plexi tubes (was protection for some ccfl light tubes iirc) that might work as small support pillars.. We'll see!

[EnJoY]

Hmm, not a lot of room as it looks right now.
But going thru some stuff at home I found some small plexi tubes (was protection for some ccfl light tubes iirc) that might work as small support pillars.. We'll see!

...waiting.

[wez]

...waiting.

Was hoping to have all stuff before the weekend, but everything is not here yet.. Only more tubing, barbs, coils etc have arrived.

And what do you guys think about these? Will I regret using 2-3 of them in a loop with two mcp655's in serie? The channel is also a couple mm smaller than my other straight barbs.. But the tube routing would get a lot cleaner..